Strain Gages Accessories
Terminals
The terminals are placed between strain gage lead and the heavier leads required for the run to measuring or recording instruments to protect strain gage leads from disconnecions or inferior insulation which are lilely to take place during strain gage installation and measurement.| Appearances | Type | Dimensions(mm) | Number of pieces per Packet | Remarks |
|---|---|---|---|---|
 |
FG-5T |
6×20×0.15 |
10 |
|
|
SFG-5T |
6×20×1.0 |
10 |
Self-Adhesive Type |
|
 |
FG-7T |
7×26×0.15 |
10 |
|
|
SFG-7T |
7×26×1.0 |
10 |
Self-Adhesive Type |
|
 |
FG-10T |
12×40×0.15 |
10 |
|
|
SFG-10T |
12×40×1.0 |
10 |
Self-Adhesive Type |
|
 |
FG-15T |
16×56×0.15 |
10 |
|
|
SFG-15T |
16×56×1.0 |
10 |
Self-Adhesive Type |
|
 |
FGR-10T |
10×25×0.15 |
10 |
For 2 or 3 Elements Gages |
|
SFGR-10T |
10×25×1.0 |
10 |
Ditto,but Self-Adhesive Type |
|
 |
FGR-15T |
15×38×0.15 |
10 |
For 2 or 3 Elements Gages |
|
SFGR-15T |
15×38×1.0 |
10 |
Ditto,but Self-Adhesive Type |
|
 |
FGF-5T |
15×40×0.15 |
10 |
For 5 Elements Gages |
|
SFGF-5T |
15×40×1.0 |
10 |
Ditto,but Self-Adhesive Type |
Adhesive
Select an adhesive that is compatible with the measurement conditions.| Type | Use | Bonded Material | Operating Temperature Range | Adhesion Method | Applied Pressure (kPa) | Capacity (g) |
|---|---|---|---|---|---|---|
|
EXTRA 4000 |
Cyanoacrylate-based
(Instant adhesives) |
Metal composite materials Plastics |
－30～70℃ |
Acupressure for more than 30 seconds |
Finger Pressure |
2g×5 |
|
F11 |
Epoxy-based two-component mixture |
Metal composite materials Plastics |
－30～130℃ |
Pressurise at 100°C for 2 hours. |
50～150 |
100g |
|
F31 |
Epoxy-based two-component mixture |
Metal composite materials Plastics |
－30～80℃ |
Pressurised at room temperature for 24 hours. |
50～150 |
100g |
Coating Material
If the measurement is to be carried out in hot and humid areas or over a long period of time, a damp-proofing agent should definitely be used.| Type | Components | Thermal Deformation Temperature(℃) | Remarks | Contents per Set(g) |
|---|---|---|---|---|
|
A-1 |
Butyl rubber |
-30～170℃
-50～200℃ |
Wear pressure with form of clay |
1000g |
|
TSE397 |
Silicone |
-55～200℃ |
General and high temperature purpose |
100g |