Specifications

Safe Overload	200 %R.C.
Maximum permissible overload	500 %R.C.
Acceptable overload of stopper	40 %R.C.
Rated Output	2 mV/V±5%
Nonlinearity	0.025 %R.O.
Hysteresis	0.025 %R.O.
Load leaving off coefficient	0.005 %/cm
Excitation Voltage	7 V  (or less)
Safe Excitation Voltage	10 V
Input Rsistance	350 Ω
Output Rsistance	350 Ω
Compensated Temp.Range	-10～45 ℃
Safe Temp.Range	-20～60 ℃
Temp.Effect on Zero	0.004 %R.O./℃
Temp.Effect on Output	0.003 %/℃
Cable	Φ4mm-4wire shielded cable, length : 2m(tip peeled off)

• Acceptable overload of stopper: The acceptable overload coefficient of stopper represents the maximum permissible overload value exceeding which the load cell in question can still retain its status as a load cell. In other words, any influences may not be produced in that load cell even in case when internal mechanisms might be damaged within this overload range.
• Maximum Side Load: The maximum side load coefficient represents the permissible load by which a load cell can endure at 90 degree angles with the loading axis of that load cell and it corresponds to 23.5 degrees if expressed by a slant angle against the loading point. Its sensitivity varies in proportion with “cosθ” but its varying accuracy is guaranteed.
• Load Leaving Off Coefficient: The load leaving off coefficient indicates the amount of variations in the output taking place when the load center leaves off from the axial center of the load cell. The leaving off distance of Model DBJ is guaranteed to be 5 cm in the maximum.